From: Santiago

Sent: Friday, July 03, 2015 2:14 PM

To: DynoMotion

Subject: Kflop E-Stop

My test with kflop, are fine and I´m going to installed in my mill,

 

but where do I have to conect the limit swich and Emergency Stop? Do I have to use the driver as limit switch?

 

Can I use pin 5 in JP4 as input with my limit switch  and pin 6 of JP4 as emergency stop? if so How I say Kflop that,

 

I have use pins 7,8,9,10,11,12,15,16,17,18,19,20,21,22 of JP7, I will install scales in the 3 axis to make the close loop.

 

regards